eh613c
09-16-2012, 06:31 PM
I want to know if it's safe to use the Valco HH with the BJCM GT. I went to a local store that had a floor sample of the GT and I brought my HH to check it out. So I installed the HH on the GT. The set up is like this:
1. the GT handle bar is adjusted almost vertical
2. the length adjuster switch (the part that attaches to the frame clamp) is at the furthest position
My concern is that with DS1's weight (37 lbs)l and the switch at its furthest position, there won't be adequate support and the arms will somehow bend.
Any BTDT? Is anyone using the HH where the switch is at it's farthest position?
1. the GT handle bar is adjusted almost vertical
2. the length adjuster switch (the part that attaches to the frame clamp) is at the furthest position
My concern is that with DS1's weight (37 lbs)l and the switch at its furthest position, there won't be adequate support and the arms will somehow bend.
Any BTDT? Is anyone using the HH where the switch is at it's farthest position?